Canonical Design Handoff
The cut list below is consumed directly from the Design Studio fabrication model; this page does not silently recompute the fronts with its standalone engine.
The cut list below is consumed directly from the Design Studio fabrication model; this page does not silently recompute the fronts with its standalone engine.
CAN Canonical Fabrication Parts Design → Production truth path
| Part family | Qty | Cut face | Thickness | Material |
|---|
01 Measurements
Fractions OK: 112 3/8, 112-3/8, 112.375
Tap an opening to switch it between door and drawer bank.
Comma-separated; widest-first fit, remainder → filler.
Wider door openings split into a pair.
Used only when exporting the STL mesh branch.
Distance from the leading edge to a left/right handle.
Distance from the top/bottom edge to the handle, when not centered.
Center-to-center hole spacing of a centered drawer pull; centers on the drawer width.
Vertical hole spacing for a two-hole door pull, measured about the handle center. 0 = single knob.
On Stile/Rail: handle centers on the front\'s frame (inset = ½ stile, vertical = ½ rail) and tracks as you change them.
01c Hardware Appearance Rendering only
Drop in a photo of the real knob or pull — it replaces the generic marker in the elevation. Geometry, holes, and the cut list are unchanged. Photos live for this session only.
none
Real-world height of the hardware, so it scales on the door.
none
Real-world width of the pull, so it scales on the drawer.
01a Drawer Banks
01b Stud Map Pre-drywall memory
From corner, comma-separated.
02 Elevation
Face frame
Door front
Drawer front
Scribe / filler
Stud (Install)
02c Handle & Hole Locator
Drag a handle to place it, or drag the blue guide line. Then push that placement to every other door.
Click a door in the elevation to select it (it highlights gold), then push its vertical position and hole c-to-c to every other door.
Or align by a draggable horizontal guide line:
03 Cut List
Fronts
—
—
04 Installation Layout Stud memory · fused grid
Stud hits inside the run
—
— mounting points
—
▸
Switch the reference view to Install Grid for red stud lines fused with the green cabinet layout. Mark from the same corner with a tape — or project the 1:1 layer.